Brodit 713392 holder Active holder Tablet/UMPC Black

Active holder for fixed installation

Description

Use an active holder for your EDA10A while driving and you will always have a freshly charged battery! The active holder is to be connected inside the dashboard. It provides a discreet and neat installation without any cables hanging over the interior. Safe and convenient! 12/24 Volt. The product is E-approved. Connect the power cable with a 2A fuse. 2,5A charger. Charging via pogo plug. Professional installation recommended. The holder is equipped with a USB-Host port so you can connect an accessory.

Easy-switching system:
The easy-switching system enables you to upgrade the holder only, and keep the installed cables. It saves you a lot of time! When upgrading to a new device, you do not longer need to make a full installation. Same goes for maintenance in case of warranty or damage. You simply disconnect the holder from the charging cable via the Molex 6-pin quick connector, and then connect the new holder. The switch is done in a few seconds.

Specifications

Design
Device mount type	Screw mount
Mobile device type	Tablet/UMPC
Compatibility	Honeywell EDA10A
Type	Active holder
Proper use	Car/Indoor
Product colour	Black
Ergonomics
Built-in charger	Yes
VESA mounting	Yes
Maximum VESA mount	75 x 75 mm
Technical details
Mobile device type	Tablet/UMPC
Compatibility	Honeywell EDA10A
Type	Active holder
Proper use	Car/Indoor
Product colour	Black
Built-in charger	Yes
Power
DC voltage range	10 - 30 V
Built-in charger	Yes